So how are producers achieving higher wheat yields? It boils down to management and conducive weather.
Wheat is often responsive to management intensification. That means selecting high-yielding and disease resistant varieties; sufficient nitrogen applications timed appropriately; controlling pests, particularly fungal diseases; and regular scouting to stay on top of other potential challenges in the field.
To assess management strategies of varying intensity, Michigan State University Extension educators Martin Nagelkirk, James DeDecker and Dennis Pennington collaborated with wheat growers on a series of on-farm research trials. The purpose of these trials was to evaluate a series of currently available management systems with successively greater intensity and input cost. Our hypothesis was that yield and profitability would increase significantly with greater management intensity.
Treatments applied were:
- Base nitrogen rate (75 to 115 pounds nitrogen per acre at green-up)
- Base nitrogen + fungicide (Prosaro or Caramba applied at flowering for control of head scab and late-season leaf diseases)
- Base nitrogen + fungicide + extra nitrogen (additional 25 to 45 pounds nitrogen per acre applied green-up first joint)
- Base nitrogen + fungicide + extra nitrogen + plant growth regulator (12 ounces per acre Palisade at first joint)
Farmers at six locations across the state participated in this study. Treatments were replicated three to four times in field scale RCBD (randomized complete block design) plots using grower equipment.
There were large differences in baseline yield potential and response to treatments between locations, with some showing not statistical difference between treatment means (Rogers City and Woodbury). The table below shows each location, treatment mean yields and the letter separation for means. At any given location, treatments with the same letter are not different from each other. Yield of treatments 2 and 3 at Hillman, 3 at Kingston, 3 and 4 at Elkton and 2 at Adrian were significantly different than the baseline management system (treatment 1). Two sites (Hillman and Adrian) apparently had enough fungal disease pressure to warrant a late fungicide application. Three sites (Hillman, Kingston and Elkton) were responsive to additional nitrogen fertilizer.
At all sites, dry weather limited head scab and leaf disease pressure, which likely reduced yield responses to late-season fungicide applications. There were hot spots of stripe rust on susceptible varieties in the study, but overall fungal disease levels in 2016 were lower than usual. At Woodbury and Rogers City, dry weather also contributed to moisture stress, which likely further limited yield response to additional inputs—there were no statistical differences between treatments. At Rogers City, moisture stress was compounded by sulfur and boron deficiencies. At the Kingston and Elton sites, responses were more typical of what is often seen in higher yielding environments. That is, yields responded favorably to elevated rates of nitrogen.
Palisade, the plant growth regulator applied in this study, is used to reduce lodging by limiting stem elongation. None of our trial sites or treatments had significant lodging this year, despite the higher nitrogen rates in treatments 3 and 4. Yield of the Palisade treatment was only significantly different from the control at one site (Elkton), where an interaction with the increased nitrogen rate in this treatment appeared to be more important (treatments 3 and 4 different from 1, but not one another).
Each farmer needs to look at the economics of increasing wheat inputs and determine which practices might benefit them the most based on plant populations, varieties planted and current management practices they employ on their farm. Fungicides for head scab control like Prosaro and Caramba cost $12-18 per acre for the product, plus an average of $8 per acre for application, totaling $20-26 per acre. With 28% UAN costing $0.39 per pound nitrogen, plus an average of $8 per acre for application, our higher nitrogen treatments cost a total of approximately $18-26 per acre. Palisade growth regular costs $12-16 per acre, plus an average of $8 per acre for application, totaling $20-24 per acre.
With wheat at approximately $5 per bushel during harvest in 2016, growers needed to increase yields by 4-5 bushels per acre to break even on each additional input of fungicide, nitrogen or the growth regular. Only treatments 3 at Kingston and 2 at Adrian achieved yields that were significantly different from the baseline system (treatment 1) and also economically profitable. If inputs can be procured at lower cost, applications costs reduced or under different (wetter) weather conditions more conducive to growth and fungal disease, the profitability of these more input-intensive scenarios could increase.
Source: Michigan State University